The Brain2pass Cisco 200-120 exam sample questions enables you to solve every question, whether it is easy or difficult. Cisco 200-120 test preparation, Cisco 200-120 dumps questions and answers, Cisco 200-120 Certification test is one such Cisco 200-120 exam examination that hands you an opportunity to exhibit your worth and market value. However, majority does not have a clue as to how should the preparation be done. Everyone wants to pass 200-120 pdf, but has no idea about the test questions, their pattern and the kind of approach they should adopt towards the preparation. Let http://www.brain2pass.com/200-120.html help you climb that ladder of success and pass your Brain2pass now!
Exam A QUESTION 1
Refer to the exhibit. What will Router1 do when it receives the data frame shown? (Choose three.)
A. Router1 will strip off the source MAC address and replace it with the MAC address 0000.0c36.6965.
B. Router1 will strip off the source IP address and replace it with the IP address 192.168.40.1.
C. Router1 will strip off the destination MAC address and replace it with the MAC address 0000.0c07.4320.
D. Router1 will strip off the destination IP address and replace it with the IP address of 192.168.40.1.
E. Router1 will forward the data packet out interface FastEthernet0/1.
F. Router1 will forward the data packet out interface FastEthernet0/2.
Correct Answer: ACF Section: (none) Explanation
Which of the following describes the roles of devices in a WAN? (Choose three.)
A. A CSU/DSU terminates a digital local loop.
B. A modem terminates a digital local loop.
C. A CSU/DSU terminates an analog local loop.
D. A modem terminates an analog local loop.
E. A router is commonly considered a DTE device.
F. A router is commonly considered a DCE device.
Correct Answer: ADE Section: (none) Explanation
Refer to the exhibit. Which three statements correctly describe Network Device A? (Choose three.)
A. With a network wide mask of 255.255.255.128, each interface does not require an IP address.
B. With a network wide mask of 255.255.255.128, each interface does require an IP address on a unique IP subnet.
C. With a network wide mask of 255.255.255.0, must be a Layer 2 device for the PCs to communicate with each other.
D. With a network wide mask of 255.255.255.0, must be a Layer 3 device for the PCs to communicate with each other.
E. With a network wide mask of 255.255.254.0, each interface does not require an IP address.
Correct Answer: BDE Section: (none) Explanation
Which layer in the OSI reference model is responsible for determining the availability of the receiving program and checking to see if enough resources exist for that communication?
Correct Answer: E Section: (none)Explanation
Refer to the exhibit. Host A pings interface S0/0 on router 3. What is the TTL value for that ping?
Correct Answer: B Section: (none)Explanation
Explanation/Reference: 400-101 vce
A network administrator is verifying the configuration of a newly installed host by establishing an FTP connection to a remote server. What is the highest layer of the protocol stack that the network administrator is using for this operation?
F. data link
Correct Answer: A Section: (none) Explanation
Refer to the exhibit. After HostA pings HostB, which entry will be in the ARP cache of HostA to support this transmission?
Correct Answer: D Section: (none)Explanation
A network interface port has collision detection and carrier sensing enabled on a shared twisted pair network. From this statement, what is known about the network interface port?
A. This is a 10 Mb/s switch port.
B. This is a 100 Mb/s switch port.
C. This is an Ethernet port operating at half duplex.
D. This is an Ethernet port operating at full duplex.
E. This is a port on a network interface card in a PC.
Correct Answer: C Section: (none) Explanation
A receiving host computes the checksum on a frame and determines that the frame is damaged. The frame is then discarded. At which OSI layer did this happen?
D. data link
Correct Answer: D Section: (none)Explanation
Which of the following correctly describe steps in the OSI data encapsulation process? (Choose two.)
A. The transport layer divides a data stream into segments and may add reliability and flow control information.
B. The data link layer adds physical source and destination addresses and an FCS to the segment.
C. Packets are created when the network layer encapsulates a frame with source and destination host addresses and protocol-related control information.
D. Packets are created when the network layer adds Layer 3 addresses and control information to a segment.
E. The presentation layer translates bits into voltages for transmission across the physical link.
Correct Answer: AD Section: (none) Explanation
All the key points of Cisco 200-120 questions and answers will be within your grasp by using the Cisco 200-120 vce questions. You can save a lot of time and money to buy and learn the Brain2pass Cisco 200-120 vce. The Brain2pass Cisco 200-120 exam sample questions cover all the important contents of the Cisco 200-120 vce for Storage Administrators. The Cisco 200-120 test questions are upgraded timely in line with the latest real Cisco 200-120 vce. We promise you a reliable, current, authentic Cisco 200-120 dumps conline testing questions, which creates an outstanding real Cisco 200-120 for Storage Administrators. You can utilize the Cisco 200-120 vce more than one time and make some alteration according to your personal needs.
For More Information – visit link below:http://www.testkingone.com/reliable-cisco-300-207-dumps-download.html
Read More: https://youtu.be/940EJjUEhBM